I built my own kegerator. bought my regulator from a reputable dealer. I bought some five gal Corney kegs.
first issue is leaking from the pop off valve on the Corney keg. C02 is leaking from the pull ring. I can put my finger on it and press it at that point is stops leaking. I walk away and come back in about ten minutes it is leaking again. any replies will be helpful.
the regulator has two issues -
a. after it has been used twice, it is less than a year old the pressure gauges are warped and do not read correctly. I cannot tell how much pressure I am putting into my kegs. The keg side is pegged even though It has no pressure on it. I can turn the pressure up or down but still shows off the scale. the pressure has never been above 12 lbs. the high pressure side I think is working properly but the metal plate inside is warped so you cannot see the correct amount of gas.
b. the pop off valve on the regulator leaks the same way the corny keg leaks. I can put my finger on it and puts it in and it will stop leaking. come back in a few minuets and it will be leaking.
any help will be grateful