So after trolling these forums for tons of information that led to my conversion to an all grain system and answers to countless other questions, I figured it was time to share...
I have acquired this
It's a steam table and when I first asked about it, it still had the water tray above the burner and cross members making it fairly strong. Now that it was gutted, it essentially has a really high wind shield. So I basically still would need to build an endoskeleton to support the kegs and mash tun. Since I got it for free, I don't see much point in spending a lot of money retrofitting this. If that's the case I might as well use this for scraps. I am also thinking about cutting a 1/3 of it off and using the lower shelf to support my boil kettle so as not to need 2 pumps.
I like the price of black pipe but the last thread to complete a closed loop is a problem.
I don't own a welder.
I am open to any and all suggestions