Ss Brewtech’s Biggest Baddest Holiday Giveaway Ever!

Home Brew Forums > Home Brewing Beer > Electric Brewing > SSR Failure
Thread Tools
Old 03-20-2011, 05:35 PM   #1
Feedback Score: 0 reviews
Join Date: Oct 2009
Location: Maynard
Posts: 198
Liked 2 Times on 2 Posts
Likes Given: 30

Default SSR Failure

at start of boil temp was coming up nice when it happened. Have had many brews on my rig with out a hitch. The line side of the ssr was where the failure occurred. By passed the SSR and continued on with the boil at 100%(i really missed the option to dial back the output). Measured the amp draw after the bypass and was in the 20-23 amp range so it was where it should have been and had the correct heat sink(40). the failure was on the input of the line side so my theory is a loose connection that would have generated heat at this point or this how they fail. Had the lp burner back up untill had controller back on line so in the end nothing lost parts on order will be ready for next brew

If you get advice on an electric brewing rig, you need to take it to a licensed electrician or two to have it looked over.
This stuff can kill you. When it comes right down to it, we're just some dudes on the internet.
I have seem some TERRIBLE advice on here in the past few months. I may even be guilty of bad advice myself.
LKHA is offline
Reply With Quote

Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Heat stick failure... ground question. Dgonza9 Electric Brewing 4 01-07-2011 01:03 AM

Forum Jump

Newest Threads