Camco quality control - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Electric Brewing > Camco quality control

Reply
 
Thread Tools
Old 03-01-2011, 03:41 PM   #1
wrench
 
wrench's Avatar
Recipes 
 
Jan 2011
Berlin, MA
Posts: 187
Liked 9 Times on 9 Posts



FedEx just delivered my new Camco ULWD 5500W Lime Life element. Woohoo! When I took at look at it, though, I became a little concerned. It's clearly in the original packaging, but if I didn't know better I would say it was used or a factory second. The element has several scratches in it that go down to bare metal. But the packaging is intact, so this had to happen before it was shrink wrapped. The hex piece between the threads and terminals also looks a little beat up with dings and dents in it. Is this common for these elements or did I get a bad one? I should probably just relax and have a HB, but thought I would ask.

 
Reply With Quote
Old 03-02-2011, 12:42 AM   #2
P-J
HBT_LIFETIMESUPPORTER.png
Recipes 
 
Mar 2010
Charlotte, NC
Posts: 3,337
Liked 301 Times on 235 Posts


Call the vendor an tell them. I'd not be concerned with the scratches but the damaged threads would concern me. IMHO.

 
Reply With Quote
Old 03-02-2011, 03:30 AM   #3
konrad
Recipes 
 
Aug 2008
Central, MA
Posts: 93

I agree. I'd try to get a replacement.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
My new Control Box... Dgonza9 Electric Brewing 19 11-09-2012 04:00 PM
Yoopers New Control Panel lschiavo Electric Brewing 69 04-13-2011 01:39 PM
SSR and heatsink inside control box? ExHempKnight Electric Brewing 9 02-15-2011 05:33 AM
Prebuilt Control Panels? weremichael Electric Brewing 22 01-09-2011 11:14 PM
control panel on/off switch stevehaun Electric Brewing 3 12-18-2010 04:49 PM


Forum Jump