Originally Posted by pennisim
Walker, that sounds like a good idea. Do you just use an immersion chiller like design?
Alternatively once I have the holes, could I use bulkhead fittings to attach to the tubing then something to attach to the coil??
Thanks in advance.
Mine is basically like an IC, but I soldered some parts to it so I could screw my temp probe into it.
If you want to go weldless, then drilling holes and putting bulkheads in it will leave you with 1/2" female ports inside (where you can use those compression fittings I was talking about) and 1/2" male port on the outside, where you can screw on hosebarbs and attach your hoses.