where is the stock temp prob on the sanyo 4912M? - Home Brew Forums
Home Brew Forums > Home Brewing Beer > DIY Projects > Kegerators & Keezers > where is the stock temp prob on the sanyo 4912M?

Reply
 
Thread Tools
Old 01-06-2011, 06:19 PM   #1
ekjohns
Recipes 
 
May 2009
IL
Posts: 1,403
Liked 22 Times on 20 Posts



I have the sanyo 4912M for a kegerator and it cycles more than I would like. I use the stock thermastat since i am not too picky about temp. The fridge runs alot and i was thinking about putting the stock probe in a gel pack to stabalize temp reading a little better as opposed to the air. Does anyone know where it is? or has anyone done this?



 
Reply With Quote
Old 01-06-2011, 06:51 PM   #2
QuixoticDevice
Recipes 
 
May 2010
Minneapolis, MN
Posts: 68
Liked 1 Times on 1 Posts


On my 4912, the probe is attached to the bottom of the coolant coil just above and slightly to the right of the drain hole.
__________________
"In my opinion, most of the great men of the past were only there for the beer."
-A.J.P. Taylor, British historian

“I like beer. On occasion, I will even drink beer to celebrate a major event such as the fall of Communism or the fact that the refrigerator is still working.”
–Dave Barry

 
Reply With Quote
Old 01-06-2011, 07:40 PM   #3
ekjohns
Recipes 
 
May 2009
IL
Posts: 1,403
Liked 22 Times on 20 Posts


would it be possible to pull it out a bit or is it pretty much stationary?

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Where to get Metal Stock? lmerg Brew Stands 15 11-13-2010 08:51 AM
Sanyo kegorator pattatat Kegerators & Keezers 1 10-21-2010 11:39 AM
Tapping stock pot? mrspock Kettles, Mash Tuns & Hot Liquor Tanks 2 04-06-2010 08:43 PM
Sanyo Kegerator Mesa512 Kegerators & Keezers 5 05-21-2009 04:45 PM
Anyone in michigan looking for steel stock TerapinChef Brew Stands 0 09-11-2008 06:24 AM


Forum Jump