Another Noob Question - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Beginners Beer Brewing Forum > Another Noob Question

Reply
 
Thread Tools
Old 01-05-2011, 05:34 AM   #1
Sleepyhound
Recipes 
 
Dec 2010
Sacramento, California
Posts: 13
Liked 3 Times on 1 Posts



Hello All,

I am relatively new to this and had a quick question about water amounts. First, I have told myself I will brew 10 basic batches before I start deviating to much, as I want to get the process down before I start doing more advanced brewing. I have bought 4 basic kits that contain LME, specialty grains, hops, and the sugars. The directions state to basically use 2.5 gallons for wort and then to dump the 2.5 gallons of wort into 2.5 gallons of water already in my fermenter (after I cool the wort). Ok, simple enough and I have done so in all my batches so far....but my question is this..

I have a 40L brew pot, doesn't it make more sense to do the entire 5 gals at once? Do I have to boil, steep, and so on with only 2.5 gals? With such a big brew pot it doesn't take long to get a boil.

Am I missing something here...advice anyone?

thanks!

 
Reply With Quote
Old 01-05-2011, 05:43 AM   #2
BrianP
 
BrianP's Avatar
Recipes 
 
Sep 2007
Dexter, MI, Michigan
Posts: 1,151
Liked 3 Times on 3 Posts


If your kettle is large enough, a full volume boil (6-ish gals reduces to 5-ish) will make a better beer. But you need a way to cool the larger volume, since you're not diluting, adding ice, etc. Full volume boil will give you better hop utilization, among other benefits.

But watch for boil-overs if the pot is near full.
__________________
Cheers,

BP

-------------------------------
Fermenter 1: Best bitter (1)
Fermenter 2: Best bitter (2)
Fermenter 3: APA
Fermenter 4: APA

 
Reply With Quote
Old 01-05-2011, 05:46 AM   #3
bad67z
HBT_SUPPORTER.png
 
bad67z's Avatar
Recipes 
 
Feb 2009
Columbus, Ohio
Posts: 1,875
Liked 110 Times on 77 Posts


Yes, they assume that most "noobs" don't have pot big enough. You will have to adjust the hops, the (hops)utilization changes with the addition of the more water in the boil. You can down load a trial version (21 days free) of one of the brewing software programs and figure out the proper hops addition adjustments. I would also suggest a wort chiller if you decide to go with full boils it makes a big differance.

 
Reply With Quote
Old 01-05-2011, 06:04 AM   #4
BrianP
 
BrianP's Avatar
Recipes 
 
Sep 2007
Dexter, MI, Michigan
Posts: 1,151
Liked 3 Times on 3 Posts


+1 on the wort chiller. I meant to mention that. An immesion chiller is a nice investment whether or not you decide to try all-grain at some point.
__________________
Cheers,

BP

-------------------------------
Fermenter 1: Best bitter (1)
Fermenter 2: Best bitter (2)
Fermenter 3: APA
Fermenter 4: APA

 
Reply With Quote
Old 01-05-2011, 07:39 AM   #5
Jamison
 
Jamison's Avatar
Recipes 
 
Oct 2010
West Central, IL
Posts: 72
Liked 1 Times on 1 Posts


40L is a big pot (about 10 gal.). I assume you will be using a turkey fryer outside as your stove would have a hard time boiling 5+ gallons of water. I steep my grains inside on the stove while my brew pot heats up outside. You don't want to use too much water when steeping your grains (something about extracting tannins). 1.5 -2 gallons for steeping should be good. 4 -4 1/2 for the boil should get you close to the 5 gal. mark when all is said and done. You will probably lose a gallon or more during the boil. Just top it off if needed.
You can get what you need for the wort chiller at the hardware store for @ $25 or so. The cold break is important so I highly recommed it.

 
Reply With Quote
Old 01-06-2011, 05:59 AM   #6
Sleepyhound
Recipes 
 
Dec 2010
Sacramento, California
Posts: 13
Liked 3 Times on 1 Posts


@BP - Ok, I understand, full volume boil = good.

@bad67z - I can do the math on the hops and I am in the process of making what I have called a "triple rib cage wort chiller", basically the rib cage design with three sets of coils that essentially form a large triangle in my 40L brewpot. I cannot wait to get my wort chiller working for my next batch.

@Jamison - Actually, while I have a turkey fryer, my propane stove in the house has no problems boiling 5gals in my 40L kettle. I will adjust for evaporation to my 5gals of tasty beer goodness.

Thank you all for answering my questions. This has not been the first nor do I expect this to be my last.

Cheers!

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
NooB question brownsbrews Beginners Beer Brewing Forum 6 06-05-2010 11:49 PM
Another Noob question cveez11 Beginners Beer Brewing Forum 2 04-18-2010 01:37 PM
noob OG question rybo1 Beginners Beer Brewing Forum 11 05-09-2009 11:54 PM
Noob question pilotchef71 Beginners Beer Brewing Forum 4 12-30-2008 02:47 AM
noob question lostnfoam Beginners Beer Brewing Forum 9 01-14-2007 03:49 PM


Forum Jump