First AG day... unexpected results - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > All Grain & Partial Mash Brewing > First AG day... unexpected results

Reply
 
Thread Tools
Old 01-04-2011, 04:59 PM   #1
GingerbreadMan
Recipes 
 
Dec 2010
Tampa, Florida
Posts: 24


Using a ten gallon Home Depot water cooler as our mash tun and pouring 170 degree water through a colander during our fly sparge every calculator has told us that we saw approx. 83 percent efficency. OUr temperature was maintained right at approx 149 degrees due to the insulation. I'm not sure that I buy our efficency being that high and are there any other ways we might be able to increase it? Thanks much for any assistance.

 
Reply With Quote
Old 01-04-2011, 05:15 PM   #2
OLDBREW
Recipes 
 
Oct 2009
SJ
Posts: 759
Liked 5 Times on 4 Posts


Add a mash-out with boiling water so the bed comes up to 165-168*F to thin the viscosity. Then use water hot enough to maintain the bed at between those temperatures throughout the sparge. You might need 180*F sparge water in the HLT. When Fly sparging, it isn't uncommon to see 88-90% eff.

 
Reply With Quote
Old 01-04-2011, 05:25 PM   #3
GingerbreadMan
Recipes 
 
Dec 2010
Tampa, Florida
Posts: 24

OK great... Thank you very much for the feedback. The only concern we had about using such hot water is that we read in several places that it would leech tannins from the grains.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Unexpected high SG bobtheUKbrewer2 All Grain & Partial Mash Brewing 4 12-17-2008 02:02 PM
The results are in for my first AG nukebrewer All Grain & Partial Mash Brewing 4 12-16-2008 08:52 PM
3rd AG much better results Diablotastic All Grain & Partial Mash Brewing 2 10-13-2008 02:03 AM
First AG Results PhilFrog All Grain & Partial Mash Brewing 2 09-02-2008 06:24 PM
The results are in. Chairman Cheyco All Grain & Partial Mash Brewing 24 04-11-2006 05:52 PM


Forum Jump