Converting Party Pump for use with CO2? - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Bottling/Kegging > Converting Party Pump for use with CO2?

Reply
 
Thread Tools
Old 12-29-2010, 12:09 AM   #1
ziddey
Recipes 
 
Dec 2010
oakland, ca
Posts: 8


First things first, are there any party pumps that have the pump attached to the side, and the beer spout coming out the top? Or did I end up with a tap coupler that's had the CO2 inlet converted for use with an air pump?

It's a Perlick unit, and currently has what seems like these two parts:
http://www.beveragefactory.com/draft...t/FN-013.shtml
http://www.beveragefactory.com/draft...t/HP-100.shtml

So if it was indeed originally a regular CO2 tap coupler, or even if not, would I be able to get this adapter, http://www.beveragefactory.com/draft...t/HP-111.shtml ?

I know the description says it's for use the other way around, but since it seems that the threading is the same on both sides for the FN-013 long adapter that I seem to have currently, I'm imagining it should work?

Also, what's the going rate for CO2 from a local supplier? I'm imagining Airgas, etc, would be where I'd want to go? Tank rental/pricing, and then further refills/exchanges?

Thanks.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Converting Sanyo4912 to kegerator (two tap) JUSTINTIMEBREWING Bottling/Kegging 1 01-28-2010 08:15 PM
Converting Sanke Kegerator RichBenn Bottling/Kegging 8 10-21-2009 06:34 PM
Converting kegerator? marano Bottling/Kegging 11 01-23-2008 04:19 PM
Converting a Carboy to a Keg rcinnovations Bottling/Kegging 33 11-14-2007 09:55 PM
Converting to two taps? carnevoodoo Bottling/Kegging 2 07-20-2007 04:23 PM


Forum Jump