Home Brew Forums > Home Brewing Beer > DIY Projects > Kegerators and Keezers > Keezer coffin questions
Thread Tools
Old 11-10-2010, 02:11 PM   #1
Feedback Score: 0 reviews
Join Date: Oct 2008
Location: NoVa
Posts: 215
Liked 6 Times on 6 Posts

Default Keezer coffin questions

Hey guys.
Looking to change from my single kegerator Summit to a keezer and love the look of the keezers some of y'all have made.
A few questions.

1) How are some of you attaching the coffin to the lid of the keezer?
2) How are you cutting the hole in the keezer lid, jigsaw? Circular saw?
3) Are you removing the old insulation in the freezer lid and replacing with foam?

Thanks so much.

skibumdc is offline
Reply With Quote
Old 11-10-2010, 03:22 PM   #2
Feedback Score: 0 reviews
Join Date: May 2009
Location: Seymour, CT
Posts: 944
Liked 63 Times on 53 Posts
Likes Given: 3


When I built mine when I had a coffin top... I first cut a hole that matched the exact cut out of the coffin then screwed and glued in the sides for it. I attached with both countersink-ed screws and bolts with nuts to ensure that the wood would not break free from the metal top of the freezer.

When I cut my holes i used a hole saw but i also have used a dremel with a metal cutting wheel to cut out a square hole which I then taped the sides with duct tape to prevent any cutting of my lines from sharp edges.

I did not remve any of the insulation in my freezer lid... I kept it where it was and have no problems.

Good Luck.

Bowtiebrewery is offline
Reply With Quote

Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
My New Fermentation coffin!! steveo929 Fermenters 9 05-21-2010 07:08 AM
Keezer questions Photopilot Kegerators and Keezers 7 03-19-2010 12:43 PM
Irish Coffin Builders Dwain Kegerators and Keezers 0 07-31-2009 06:06 PM
The Keezer is GO!!! Some questions! lucasszy Kegerators and Keezers 1 03-07-2009 09:18 PM
New Keezer Questions AGBrewer Kegerators and Keezers 4 10-21-2007 06:22 PM

Forum Jump