Using 1" Camlock for quick release element? - Page 4 - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Electric Brewing > Using 1" Camlock for quick release element?

Reply
 
Thread Tools
Old 12-02-2011, 09:00 AM   #31
HopSecret
Recipes 
 
Jan 2009
Florida
Posts: 34

Thank you Bobby M. That was what I was worried about. So you would have to have a 1.5" Camlock pair and a 1.5" to 1" bushing to make this work.

 
Reply With Quote
Old 12-02-2011, 02:54 PM   #32
Bobby_M
Vendor and Brewer
HBT_SPONSOR.png
 
Bobby_M's Avatar
Recipes 
 
Aug 2006
Whitehouse Station, NJ
Posts: 23,205
Liked 1660 Times on 1073 Posts


Well, I'd lean towards drilling and tapping out a 1.5" Dust Cap just due to cost and simplicity. I'd also only go after this if you're able to solder or weld a bare bones Male cam QD to your vessel. Making 1.5" NPT weldless would be a major PIA.
__________________
Welcome to BrewHardware.com. I love you.
BIAB Large Mesh False Bottoms and SS HERMS COILS are IN!!
Chugger Pumps, Pump Kits, Camlocks, Sightglasses, Clear USA made Silicone Tubing, RIMS, Electric Install Parts, etc.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Heating element questions Patirck Electric Brewing 36 04-20-2012 12:18 PM
208 volt element Budzu Electric Brewing 14 11-06-2010 02:19 AM
my take on covering the heating element connections Broncobum Electric Brewing 30 11-05-2010 06:25 PM
Where did you get your heating element? CircleC-Brewer Electric Brewing 20 10-29-2010 02:26 PM
Did I just ruin my element? dboblitt Electric Brewing 3 10-11-2010 06:02 PM


Forum Jump