UPDATE: Well kind of......
I've been working on converting the drawing I stole from Ed's BCS-460 build to my BrewTroller build and I'm having a hard time wrapping my brain around how BrewTroller interfaces with the 3 Position selector switches for my heating elements, and how to run my pumps power from the breaker to BrewTroller for it to control through the 3 position selector switches as well.
I'm good wiring my 12VDC valves and 12VDC stir motor for my HEX through the relay board, but again interfacing the board with the switches is giving me a headache, these will be on off on toggle switches.
Here's what I have for drawings.
First is something that is actually done! My control panel layout. The textured outline is the foam on the back side of the panel.
Next is my main drawing. I think I'm pretty solid on my high voltage wiring but if anyone sees anything alarming let me know. The low voltage is giving me a headache like I said.
Finally I have a breakout drawing of 1 output of the 16 Port Relay board showing wiring for a valve. I'm a little lost how to wire the DPDT on off on toggle from the three pin header. The drawing shows one of the heat output headers as well, still confused how this corresponds to the 3 Position Selector Switches. I think I've got the wiring for the SSR's correct but please take a look in the main drawing.
Long and short, I'm progressing but I need some direction on how BrewTroller interfaces with the switches. If I were just wiring the switches without BrewTroller I'd be fine, the low voltage is confusing the crap out of me!
Just looked a the pic of the drawing and it's too small to see
I have a PDF but it's 37KB. Crap, any ideas how to attach the drawing???