What type of tail piece to use when serving soda? - Home Brew Forums
Register Now For Free!

Home Brew Forums > Wine, Mead, Cider, Sake & Soda > Soda Making > What type of tail piece to use when serving soda?

Reply
 
Thread Tools
Old 09-06-2010, 02:37 AM   #1
reidoreilly
Recipes 
 
Nov 2007
Posts: 9


So i've been setting up my bar getting ready for football season and got some soda going. I went to drink it at first and it tasted fine, but a day later its got an off taste. So I check the lines everything was fine, and then I noticed the tail piece was rusted. I installed it about 2 years ago, and I have no idea what type of metal I used or where I got it from. Its a silver color so my guess is stainless or nickle, but I was under the impression those wouldnt rust.

 
Reply With Quote
Old 09-06-2010, 05:53 AM   #2
PintOfBitter
 
PintOfBitter's Avatar
Recipes 
 
Feb 2007
USA
Posts: 1,154
Liked 11 Times on 10 Posts


you probably would have had the same problems with beer - brass or stainless would work great (stainless always has a narrow advantage). Plated fittings can give you trouble, since it doesn't take much to breach the plating somewhere, and then it's all over.
__________________
-PoB

Maybe you can use these Grain, Hops, Yeast Reference Charts

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Getting Into Soda Joeywhat Soda Making 2 11-24-2009 10:55 PM
New to Soda JDengler Soda Making 3 09-29-2009 07:02 AM
how long does soda need to sit? jgardner6 Soda Making 6 01-21-2009 09:24 PM
De-caf soda zac Soda Making 7 11-11-2008 09:01 PM
New to soda ajk170 Soda Making 5 10-03-2008 10:36 PM


Forum Jump