Brutus Build Valve orientation question - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > Brutus Build Valve orientation question

Reply
 
Thread Tools
Old 05-31-2010, 04:11 AM   #1
TriggerDog
Recipes 
 
Apr 2010
Calgary
Posts: 7


Brutus Build Valve orientation question

So I am now doing the final assembly of my Brutus clone and I wanted to know if any one has an opinion or recommendation for valve orientation. I see that most build have the vales right after their pots/keggles and then the tee with the thermowells and disconnects. I was thinking of putting the valve pointing downward after the tee. I have attached a link to a picture to show the different. Any suggestion with which way is better or problems with the orientation? Valve down on the right, valve after pot of the left.

http:[email protected]/4655169650/

Thanks,

Mike

 
Reply With Quote
Old 06-02-2010, 01:53 AM   #2
BargainFittings
Sponsor
HBT_SPONSOR.png
 
BargainFittings's Avatar
Recipes 
 
Nov 2008
Allen TX
Posts: 2,031
Liked 88 Times on 78 Posts


I would think it depends on your rig. You can do a run with water, hot or not and see how ergonomic it is to change out. Try it with hot water to see if it is comfortable handling the disconnects etc.

Most have them straight out but the tee down could work too.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Brutus 10 ASCO Valve jgardner6 General Beer Discussion 5 07-13-2014 11:22 PM
Brutus 10 / NG valve question ggltd Brew Stands 0 05-28-2010 09:59 PM
Yet another Brutus build gunmetal Brew Stands 6 05-11-2010 02:02 PM
Brutus Build Question Brewpatrol Brew Stands 13 02-26-2010 05:47 AM
NEED HELP - PID and gas valve setup for Brutus 10 jsocha389 Brew Stands 8 09-15-2009 09:08 PM


Forum Jump