control box / enclosures - some tips for anyone considering it - Page 5 - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > DIY Projects > Brew Stands > control box / enclosures - some tips for anyone considering it

Reply
 
Thread Tools
Old 03-18-2010, 04:58 AM   #41
Walker
I use secondaries. :p
HBT_LIFETIMESUPPORTER.png
 
Walker's Avatar
Recipes 
 
Sep 2005
Cary, NC
Posts: 10,987
Liked 101 Times on 89 Posts


Quote:
Originally Posted by Walker View Post
I'll measure carefully tonight if it isn't stamped or stickered right on the box itself.
I tried to get a picture of a piece of the steel up against a ruler, but could not get a good shot.

At any rate, I measured the thickness and it is a tad over 2.5mm. According to this table (http://www.mesteel.com/info/carbon/thickness.htm), that puts my box at 12 gauge. It's not 1/8", but it's pretty goddamn thick.
__________________
Ground Fault Brewing Co.

 
Reply With Quote
Old 03-20-2010, 02:40 AM   #42
Walker
I use secondaries. :p
HBT_LIFETIMESUPPORTER.png
 
Walker's Avatar
Recipes 
 
Sep 2005
Cary, NC
Posts: 10,987
Liked 101 Times on 89 Posts


Today is a glorious day.

I finally moved on to cutting the front panel after finishing the cutting I had to do on the inside panel and rear of the box.

The steel used for the front door of this m*therf*cker is SIGNIFICANTLY thinner than the rest of the box. I'm finishing this baby tonight.....
__________________
Ground Fault Brewing Co.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Brewing-tips.com - Daily Brewing Tips Website onelegout General Beer Discussion 13 06-08-2010 12:42 PM
Tips on using DME BigE Beginners Beer Brewing Forum 21 06-19-2009 08:05 PM
WTT Propane Burner tips for Nat Gas tips Mirilis For Sale 0 05-28-2009 05:39 PM
Red Ale Tips SpeedfReako5 Beginners Beer Brewing Forum 2 04-10-2009 06:53 AM
Thanks for the Tips Chip General Techniques 3 07-02-2008 02:46 AM


Forum Jump