looking for a specific fitting - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > looking for a specific fitting

Reply
 
Thread Tools
Old 03-05-2010, 05:22 PM   #1
Windsors
Recipes 
 
May 2008
Posts: 102
Liked 2 Times on 2 Posts



Thought I would give this a try here.

I am looking for a 1/2" male coupling or nipple (1/2" male threads both sides) that has 3/8" threads on the inside of one the ends.

I want to be able to thread this into a 1/2" female coupling that cam on my Plastic Mini brew HLT that I use. i want to be able to make a hrad connection with my HERMS coil inside the tank through these couplings and need threads to go both ways.

Thanks


Bill

 
Reply With Quote
Old 03-05-2010, 11:56 PM   #2
GreenMonti
HBT_SUPPORTER.png
Recipes 
 
Nov 2009
Posts: 1,147
Liked 23 Times on 20 Posts


Get the tools out cause you gonna need to make that fitting. Your other option is to drill the side of your HLT for the HERMS coil.

 
Reply With Quote
Old 03-06-2010, 12:31 AM   #3
BargainFittings
Sponsor
HBT_SPONSOR.png
 
BargainFittings's Avatar
Recipes 
 
Nov 2008
Allen TX
Posts: 2,052
Liked 95 Times on 84 Posts


I suspect you will have to do that or use a conversion fitting to get to the thread you need.

How much slack do you have for the coil in the HLT? Just as well use the reducing coupling and a 3/8" nipple.

Does the 1/2" nipple need to go through the wall of the hlt?

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Need a fitting. crawford Bottling/Kegging 4 02-09-2010 02:47 AM
fitting Wade E Kettles, Mash Tuns & Hot Liquor Tanks 2 01-08-2010 02:15 AM
Brass fitting ftrombley Beginners Beer Brewing Forum 1 09-01-2009 08:03 PM
Burner LP fitting ? Gabe Equipment/Sanitation 7 02-24-2008 02:32 PM
Fitting help Beer Snob All Grain & Partial Mash Brewing 22 02-25-2006 06:46 AM


Forum Jump