interior view. Regulators sit in the freezer compartment (I removed the plastic freezer door). There's a shelf built that can hold the five kegs that fit. Right now I have four in. The fifth sits in the center between them all.
Inside the door. The interior shelf panel was removed and replaced with pebble board which has been reversed so the smooth side is showing. The four foot beer lines hang down but the door closes fine and there is clearance so when they are disconnected they just hang. High point is the shank.
A different angle so you can see the keg in the back corner.
here is the five stage secondary regulator. Gas comes in on the right side and works through. I also have a beergas line run in but it just uses the exterior primary regulator on the tank and runs to a single gas connector on the inside.