Cyser in the making - questions - Home Brew Forums
Home Brew Forums > Wine, Mead, Cider, Sake & Soda > Mead Forum > Cyser in the making - questions

Reply
 
Thread Tools
Old 01-28-2010, 02:00 AM   #1
dacole
Recipes 
 
Dec 2009
Saskatchewan
Posts: 34


Hello everybody,

I started a Cyser on Saturday January 16th with the following recipe:

2.2 lbs honey
1 gallon apple juice (spreadsheet says 0.81 gallons)
1/2 packet 71B-1122
ĺ tsp nutrient
Ĺ tsp energizer

Its been going now for a week and a half and I have a few questions about it.

1. The airlock is popping every 30 seconds right now. Would this be typical or would it normally be faster then that?
2. I read some where that you can measure the SG one day, then measure it again 3 days later and if the SG hasn't changed in that time, then that means the yeast is done fermenting. Is that true?
3. Lastly, should I be leaving this in the bottle untill it clears or should I be racking it off after it is done fermenting whether it is clear or not?

Thanks.



 
Reply With Quote
Old 01-28-2010, 12:18 PM   #2

1. Bubbles in the airlock are not a reliable indication of fermentation.
2. Not necessarily. You could have a stuck fermentation. When your cyser reaches .998 or lower with this recipe and there has been no change after three days then you can count on the fermentation being complete.
3. Rack it off the lees at least once after primary fermentation is complete. It will still be cloudy at this time. Allowing it to sit on the gross lees from the initial fermentation may likely result in off flavors.



 
Reply With Quote
Old 01-28-2010, 10:02 PM   #3
dacole
Recipes 
 
Dec 2009
Saskatchewan
Posts: 34

Thanks for the response summersolstice. I am starting to think the fermentation is done, or close to it because the SG I measured today was 1.002. I will check it again on Sunday and if it hasn't changed, I will call it done and rack it.

 
Reply With Quote
Old 01-29-2010, 02:49 PM   #4
dacole
Recipes 
 
Dec 2009
Saskatchewan
Posts: 34

Here is a picture of what it looks like so far. Since its a little short from the neck and will get shorter when I rack it off, should I be adding water or apple juice back in to bring it back up to the neck?


 
Reply With Quote
Old 01-30-2010, 01:26 AM   #5

Yes, you want to top it off. You have a couple of options: top it off with water after racking or allow it to ferment to dryness (.996 or below) and stabilize with sorbate and k-meta and top and backsweeten with pure frozen concentrate (for more apple flavor and sweetness) and some honey dissolved in warm water. If you top with juice without stabilizing, you'll restart the fermentation and basically be back at step one.

 
Reply With Quote
Old 01-30-2010, 04:28 AM   #6
dacole
Recipes 
 
Dec 2009
Saskatchewan
Posts: 34

Sounds good. Thanks again for your help.

So if I want to just use water will I need to stabilize? My guess is no because the sugar content that is left is minimal.

 
Reply With Quote
Old 01-30-2010, 06:28 AM   #7
AnthonyD
Recipes 
 
Dec 2009
Rochester,NY
Posts: 151

Could you also just top off with sorbate treated apple juice?
__________________
"We brewers donít make beer, we just get all the ingredients together and the beer makes itself."
~ Fritz Maytag, President Anchor Brewing

Reason: spelling

 
Reply With Quote
Old 01-30-2010, 02:47 PM   #8

You'll want to stabilize prior to bottling unless you bulk age for 6-8 months or more or if you'll be bulk aging cooler than 55F or so otherwise fermentation could start back in the bottle.

 
Reply With Quote
Old 01-30-2010, 03:38 PM   #9
dacole
Recipes 
 
Dec 2009
Saskatchewan
Posts: 34

I was kind of basing this off of the write up on this website which mixes it up in a gallon jug and lets it sit in the jug for 1-3 months, then bottles when it is clear, which I believe is similar to JOAM:

http://badger.cx/brewing/cyser.html

Maybe I will just let this one sit a few more months until it clears up and next time try fermenting this in a plastic fermenter, changing the recipe so that it is ~1.25 gallons instead of 1. So that way when I rack it off for bulk aging, I should be able to fill the gallon jug and not have to use the stabalizers.



 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
1 gallon cyser questions? brewstead Cider Forum 2 10-29-2008 11:17 PM
Cyser questions Llama Cider Forum 6 10-05-2008 07:29 PM
More Cyser Questions russb123 Cider Forum 5 10-04-2008 08:59 PM
A few cyser questions from a noob Rhinofly Cider Forum 11 09-22-2008 01:21 AM
Cyser questions? russb123 Cider Forum 6 09-19-2008 06:11 PM


Forum Jump