Cooler Spigot Question - Home Brew Forums
Register Now For Free!

Home Brew Forums > Home Brewing Beer > DIY Projects > Kettles, Mash Tuns & Hot Liquor Tanks > Cooler Spigot Question

Reply
 
Thread Tools
Old 12-12-2009, 04:49 PM   #1
1234
Registered User
Recipes 
 
Mar 2009
Hendersonville, TN
Posts: 1,539
Liked 6 Times on 6 Posts



I am making wanting to make a new mash tun and I can buy a cooler for $10, but it's spigot is in the middle. I would assume that it shouldn't matter, I would just need to make a different manifold. Doe anybody have one like this?

 
Reply With Quote
Old 12-12-2009, 07:04 PM   #2
mike1978
Recipes 
 
Nov 2009
Denver, NC
Posts: 136

It doesn't matter where the spigot is.
Check out www.donosborn.com and see his cooler mash tun. I did the exact same one from his website, total cost was $19.75 with cooler. I have used it 6 or 7 times so far with no problems at all.

 
Reply With Quote
Old 12-12-2009, 08:51 PM   #3
wilserbrewer
BIAB Expert Tailor
HBT_SPONSOR.png
 
wilserbrewer's Avatar
Recipes 
 
May 2007
Jersey Shore, New Jersey
Posts: 9,702
Liked 1466 Times on 1116 Posts


Shouldn't really matter where the drain is. If you have a drill and bits, you could add another wherever you like.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Good Mash Tun? Rectangular Cooler w/ Spigot on Long Edge hokenfloken Equipment/Sanitation 2 12-02-2009 06:57 PM
2 5 gallon igloo seat top cooler w/spigot brewsbrothers Kettles, Mash Tuns & Hot Liquor Tanks 3 10-30-2009 12:46 AM
Spigot Question justin81 Equipment/Sanitation 2 05-16-2009 06:13 PM
Drilling cooler for spigot - bad idea? Soulive Equipment/Sanitation 22 09-22-2008 06:04 PM
Question about spigot usage IlliniSox4Life Equipment/Sanitation 4 05-06-2008 05:27 AM


Forum Jump