Home Brew Forums > Home Brewing Beer > Bottling/Kegging > Firestone Keg Rebuild
Reply
 
Thread Tools
Old 12-01-2009, 08:42 PM   #1
Dan2539
Feedback Score: 0 reviews
Recipes 
 
Join Date: Nov 2009
Location: South Jersey
Posts: 101
Default Firestone Keg Rebuild

I have a bunch of firestone kegs that have been sitting in my basement forever and itís been years since they have been used. After cleaning them properly and probably replacing the o-rings on all of them is it a good idea to replace the poppet valves as well or is this unnecessary? Also, I'm not quite sure which type of keg they are. They are pin lock kegs but they are model F. They don't have a challenger type stamped on the side.


Dan2539 is offline
 
Reply With Quote
Old 12-01-2009, 09:00 PM   #2
Walker
I use secondaries. :p
HBT_LIFETIMESUPPORTER.png
Feedback Score: 0 reviews
 
Walker's Avatar
Recipes 
 
Join Date: Sep 2005
Location: Cary, NC
Posts: 11,244
Liked 97 Times on 86 Posts
Likes Given: 11

Default

If the poppets seem in good shape and the kegs hold pressure when no lines are attached, they probably don't need to be replaced.
__________________
Ground Fault Brewing Co.
Walker is offline
 
Reply With Quote
Old 12-01-2009, 10:10 PM   #3
Dan2539
Feedback Score: 0 reviews
Recipes 
 
Join Date: Nov 2009
Location: South Jersey
Posts: 101
Default

Sounds good, thanks alot
Dan2539 is offline
 
Reply With Quote
Reply


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Finally starting to rebuild - my wip HLT ScottD13 Kettles, Mash Tuns, & Hot Liquor Tanks 5 12-30-2009 02:25 PM
Kegerator Rebuild? Mountainbeers Bottling/Kegging 3 09-01-2009 12:29 AM
regulator rebuild? planenut Bottling/Kegging 3 01-22-2009 03:58 PM
Pump rebuild Brewpastor Equipment/Sanitation 8 03-14-2007 05:56 PM
Faucet rebuild supplies JnJ Equipment/Sanitation 8 01-14-2007 01:49 PM


Forum Jump

Newest Threads

LATEST SPONSOR DEALS