O2 pressure from welding tank - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Equipment/Sanitation > O2 pressure from welding tank

Reply
 
Thread Tools
Old 10-29-2009, 01:11 AM   #1
Cold_Steel
Recipes 
 
Apr 2009
Posts: 558
Liked 1 Times on 1 Posts



I have a welding tank that I am using to oxygenate my wort. I am using a .02 micron stone. What do I set the regulator for or how much psi?
Thanks
__________________
Quote:
Originally Posted by jpc
Doesn't blowing on it when its soft cause it to get hard? It's been a while, but I think that's how it used to work...

 
Reply With Quote
Old 10-29-2009, 01:13 AM   #2
Yuri_Rage
Gritty.
HBT_MODERATOR.png
 
Yuri_Rage's Avatar
Recipes 
 
Jul 2006
Southwest
Posts: 14,285
Liked 804 Times on 510 Posts


Set it for zero, then open the tank valve. Slowly increase the regulator setting until small bubbles begin rising to the surface of the wort. It won't take much.
__________________
Homebrewed Blog..........YouTube Channel .......... Shirts, posters, etc

 
Reply With Quote
Old 10-29-2009, 01:17 AM   #3
Cold_Steel
Recipes 
 
Apr 2009
Posts: 558
Liked 1 Times on 1 Posts


thank you sir!
__________________
Quote:
Originally Posted by jpc
Doesn't blowing on it when its soft cause it to get hard? It's been a while, but I think that's how it used to work...

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Co2 Tank Pressure? BrewSapiens Bottling/Kegging 11 04-28-2010 08:28 PM
Welding Place would not fill my co2 tank AJC16 Bottling/Kegging 6 10-20-2009 06:24 PM
CO2 Tank Pressure beilber Equipment/Sanitation 6 07-26-2009 05:55 PM
Pressure on new CO2 tank levians69 Bottling/Kegging 8 01-14-2009 08:26 PM
How much should the tank pressure GIusedtoBe Bottling/Kegging 13 11-20-2007 08:08 PM


Forum Jump