Screwed up my Mash Tun - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > DIY Projects > Kettles, Mash Tuns & Hot Liquor Tanks > Screwed up my Mash Tun

Reply
 
Thread Tools
Old 09-23-2009, 03:11 PM   #1
1234
Registered User
Recipes 
 
Mar 2009
Hendersonville, TN
Posts: 1,539
Liked 6 Times on 6 Posts



Hey guys I could use some help. I traded a keggle for rubber coated keg that I planned to use as my mash tun. When I went to drill the pilot hole I realized I was a little low so I moved my bit just a bit higher thinking that it would round out into the initial pilot hole. Now I have a hole that has a extra little taken out of the bottom, can you help. I would post a picture but I am not sure how. If I figure it out I will post a picture.

 
Reply With Quote
Old 09-23-2009, 03:13 PM   #2
IrregularPulse
Hobby Collector
HBT_LIFETIMESUPPORTER.png
 
IrregularPulse's Avatar
Recipes 
 
Nov 2007
Posts: 50,611
Liked 3402 Times on 3249 Posts


JB welt to patch it then reshape the hole. No welding required. Or if it's through rubber, use hightemp silcone.
__________________
Tap Room Hobo

I should have stuck to four fingers in Vegas.

 
Reply With Quote
Old 09-23-2009, 03:45 PM   #3
samc
Recipes 
 
Aug 2008
Portland OR
Posts: 5,387
Liked 62 Times on 58 Posts


Depending on how much extra opening you created it might be simpler to buy a larger silicone o-ring and SS washer to cover the over sized hole.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Mash WAY too low...screwed? theganda All Grain & Partial Mash Brewing 4 10-01-2009 12:52 AM
I do believe i just screwed up..... jasonjrw Beginners Beer Brewing Forum 3 04-24-2009 02:11 AM
Just screwed up... Coy-Boy General Techniques 3 04-15-2009 05:04 PM
Screwed up my Hefe multi step mash megavites All Grain & Partial Mash Brewing 3 06-05-2007 01:42 AM
Screwed up...maybe? myersn024 Recipes/Ingredients 6 09-12-2006 05:57 AM


Forum Jump