Mash Profile questions - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > All Grain & Partial Mash Brewing > Mash Profile questions

Reply
 
Thread Tools
Old 08-03-2009, 01:49 AM   #1
Blindguardian
Recipes 
 
Apr 2009
Alabama
Posts: 161
Liked 1 Times on 1 Posts



First let me say this is a great place with allot of great information and people.

My questions are these:

On a single infusion with no mash out, the mash in step states to add 2.33gal of water at 163.8. I understand this part of the process but the part that I am not sure of is after. The instructions in beersmith states to sparge with 6.49 gal of 180 water. This is the part that I am not sure of. I do not have the means of doing a running sparge... so the only thing that I have done to this point is batch sparge.

Do I just add 6.49 gal to my MLT after I drain the first 2.33 gal then drain that with out letting it sit for any amount of time?

Am I understanding the instructions right by doing it that way?

the recipe that I am planing on doing in a day or two is this one Cream of Three Crops scaled to a 5 gal batch size.

 
Reply With Quote
Old 08-03-2009, 03:17 AM   #2
ArcaneXor
 
ArcaneXor's Avatar
Recipes 
 
Nov 2007
Posts: 4,572
Liked 117 Times on 104 Posts


That's the gist of it - though I personally prefer to do two sparges whenever possible (i.e. in this case, I'd batch sparge twice with about 3.25 gallons each), and let it sit for 5-10 minutes prior to draining to let the grain bed settle.

 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Mash Profile Cheat Sheet Yuri_Rage All Grain & Partial Mash Brewing 5 11-28-2010 06:05 PM
Porter and Flavor Profile Recipe Questions Jeffo Recipes/Ingredients 2 03-29-2009 11:07 PM
Mash Profile in Beersmith Hawgbranch Brewing Software 4 02-21-2009 06:42 PM
Mash Temp Profile question Rethin All Grain & Partial Mash Brewing 6 03-05-2007 06:22 AM


Forum Jump