CO2 Regulator barb - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Bottling/Kegging > CO2 Regulator barb

Reply
 
Thread Tools
Old 07-28-2009, 11:33 PM   #1
pjk49202
Senior Member
HBT_LIFETIMESUPPORTER.png
 
pjk49202's Avatar
Recipes 
 
Mar 2009
Parker, CO, Colorado
Posts: 234
Liked 3 Times on 3 Posts



I recently bought a CO2 regulator with a 3/8 barb on the outlet. But, when I connect a 3/8 line to the inlet of the keg, 1/4 barb, I have a leak no matter how tight I make the hose clamp.

Does anyone know of what to do in this situation?

I was thinking about buying another barb somewhere but I couldn't unscrew it from the regulator.

Thanks in advance!

 
Reply With Quote
Old 07-29-2009, 02:29 AM   #2
pjk49202
Senior Member
HBT_LIFETIMESUPPORTER.png
 
pjk49202's Avatar
Recipes 
 
Mar 2009
Parker, CO, Colorado
Posts: 234
Liked 3 Times on 3 Posts


LOL wow, I'm losing it. Seal on regulator and keg are fine.

 
Reply With Quote
Old 07-29-2009, 03:27 AM   #3
leboeuf
Recipes 
 
Feb 2009
Albuquerque, NM
Posts: 320
Liked 2 Times on 2 Posts


Huh? I just mash my 1/4" line onto the 3/8" barb.

 
Reply With Quote
Old 07-29-2009, 12:58 PM   #4
JohnnyKim
Recipes 
 
Sep 2008
East Brunswick, NJ
Posts: 54

dont over tighten the clamp.

and lebeuf, OP is connecting it reverse...3/8" line to 1/4" barb.

i would say get a new barb.


 
Reply With Quote
Reply
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Barb Fitting differences SPLASTiK Equipment/Sanitation 8 05-10-2009 12:05 AM
5/16 gas line to 1/4 barb fittings madcapstudios Bottling/Kegging 14 04-02-2009 07:45 PM
Barb or Flare? fifelee Bottling/Kegging 9 06-29-2007 06:00 PM
Can't get hose and barb to seal FlyingHorse Bottling/Kegging 12 05-17-2007 08:53 AM
Regulator barb is 5/16 and gas-in connector barb is 1/4 ??? Kaiser Bottling/Kegging 1 02-22-2006 02:14 PM


Forum Jump