3" PVC Tower - Home Brew Forums

Register Now!
Home Brew Forums > Home Brewing Beer > Bottling/Kegging > 3" PVC Tower

Thread Tools
Old 07-24-2009, 03:55 AM   #1
Apr 2009
Posts: 1

I built my own tower from a mini fridge. What type of shank can I use to accomodate the curve of the circular tower. Is there a good place to buy this type of shank. The shank also needs to be at a 90 degree angle because of the small space in the tower.

Reply With Quote
Old 07-24-2009, 03:59 AM   #2
Jan 2008
Milwaukee WI / Mankato MN
Posts: 356
Liked 3 Times on 2 Posts

Right here It also is rounded off to form along the curve of the tube. Welcome to the forum!

Reply With Quote
Old 07-24-2009, 02:07 PM   #3
Feb 2008
Jay, Maine
Posts: 117
Liked 3 Times on 3 Posts

When I built mine I put a 3" to 4" pvc adapter on top that gave me some extra room to play with for my tubing. I capped it with a half round pvc cap that fit the 4" opening. This gave it a mushroom cap look that you can find in some of the commercial towers.

Reply With Quote
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
Kegerator tower "up"grade; need tap handle ideas. danotts Equipment/Sanitation 4 02-19-2010 03:38 PM
Where can I get a "cap" for the tower on my kegerator? commonlaw Bottling/Kegging 2 10-19-2009 06:29 PM
"spare parts" of tower rhltechie Kegerators & Keezers 17 08-26-2009 11:55 PM
All Stainless 3" Tower Shanks? hukdizzle Bottling/Kegging 2 05-04-2009 08:51 PM
3" tower; to screw or bolt? aekdbbop Equipment/Sanitation 13 01-05-2007 04:23 AM

Forum Jump