Originally Posted by humblesea
Ok that makes sense, but I don't even get how to set P5 to 1? Is this all done from the front three buttons?
From the manual
•Press SET for 8 seconds. Value 0 will blink.
•With UP and DOWN input the code (factory set as 0).
•Press SET to confirm the code. If correct, the label of the first
parameter will be displayed.
•With UP or DOWN go to the desired parameter in the parameter
•Press SET to see the value.
•With UP or DOWN change the value to the new value as desired.
•Press SET to confirm and exit again to the parameter list. (Also to
exit to the list without parameter modification.)
•Press SET + DOWN to exit setup or wait for 1 minute.