washer for blichmann false bottom
- Thread starter Mojoe4
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
RiverCityBrewer
Well-Known Member
Measured mine with calipers... 1.5" OD and .515" ID
wildwest450
Well-Known Member
- Joined
- Dec 27, 2007
- Messages
- 8,978
- Reaction score
- 191
Ugg, I know i'm going to lose mine at some point, I should have it spot welded on.
Wonder if you could still get the dip tube in there, hmmmm.
_
Wonder if you could still get the dip tube in there, hmmmm.
_
Doing a bit of a thread necro here, but I figure I can't be the only person who who's done this. I recently lost the washer for my false bottom and I ended up replacing it with these
http://www.mcmaster.com/nav/enter.asp?partnum=91525A145
They're 316 stainless and they seem to fit like a glove, I bought a 10 pack and they came out to a little less than a dollar a pop shipped.
http://www.mcmaster.com/nav/enter.asp?partnum=91525A145
They're 316 stainless and they seem to fit like a glove, I bought a 10 pack and they came out to a little less than a dollar a pop shipped.
I really hate links to McMaster-Carr - never points directly to the item from outside the website.
Is the right one? 91525A145
Thank you!!!
Is the right one? 91525A145
Thank you!!!
yup 91525A145, sorry about the link.
No worries and thank you very much!
Similar threads
Latest posts
-
-
-
-
Lots of grain mush in the wort and scorching- Latest: iandanielursino
-
-
-
-