Diablotastic
Well-Known Member
So I'm thinking about putting a motor on my Corona Mill.
I have access to a 110V 1/4 HP 1700ish RPM motor.
Been playing around with some ideas on how to slow down the RPM's and it seems like I would need a fairly big flywheel on the mill which I'm not sure I'm digging yet.
Has anybody tried a fairly standard off the shefl fan control switch to limit the current to the motor?
I guess i could look into a VFD but I'm thinkin that could get pricey
Any thoughts?
I have access to a 110V 1/4 HP 1700ish RPM motor.
Been playing around with some ideas on how to slow down the RPM's and it seems like I would need a fairly big flywheel on the mill which I'm not sure I'm digging yet.
Has anybody tried a fairly standard off the shefl fan control switch to limit the current to the motor?
I guess i could look into a VFD but I'm thinkin that could get pricey
Any thoughts?