Skrimpy
Well-Known Member
So I have this thing wired up and ready to enclose in a box the same as this thread:
https://www.homebrewtalk.com/f51/another-tss2-controller-box-build-195713/
which is in agreement with the Dwyer diagram posted by this user:
https://cdn.homebrewtalk.com/galler...2100-wiring-diagram-w-2f-terminal-block&cat=1
My problem is I have the temp probe suggested (TS-61) and it has two wires to connect to the TSS2. In the diagram one is going into connector 1 (labeled SD1) and the other into the unmarked connector 3 with nothing going into connector 2. Problem I have is that one is red and one is blue. Does it matter which goes into which connector? Am I going to fry my panel if I wire it backwards?
https://www.homebrewtalk.com/f51/another-tss2-controller-box-build-195713/
which is in agreement with the Dwyer diagram posted by this user:
https://cdn.homebrewtalk.com/galler...2100-wiring-diagram-w-2f-terminal-block&cat=1
My problem is I have the temp probe suggested (TS-61) and it has two wires to connect to the TSS2. In the diagram one is going into connector 1 (labeled SD1) and the other into the unmarked connector 3 with nothing going into connector 2. Problem I have is that one is red and one is blue. Does it matter which goes into which connector? Am I going to fry my panel if I wire it backwards?