dregus
Well-Known Member
Hello all,
Thanks for all the help in the past. I recently attempted to convert a frig to a kegerator. I hit the copper pipe in the side of the frig and it let out all the gas. I have found out that I cannot repair it without spending a bit of money.
Does anyone have suggestions on how to determine where the lines are prior to drilling? What is the best way to make the conversion?
Dennis
Thanks for all the help in the past. I recently attempted to convert a frig to a kegerator. I hit the copper pipe in the side of the frig and it let out all the gas. I have found out that I cannot repair it without spending a bit of money.
Does anyone have suggestions on how to determine where the lines are prior to drilling? What is the best way to make the conversion?
Dennis
