Pin-locks with no pressure valve

I was given a bunch of Coke pin lock kegs.
I need to see if two will fit in my Sanyo, then clean and refurbish them.
My concern is the lid doesn't have a pressure relief valve like on my ball locks.
It has a safety release molded into the lid, but you can't pull the pressure yourself.
How can you release it on this type?
I can post a picture later.

You can make a little pressure relief device to hook-up to the gas side, other than that, there really isn't a good way to do it.

I have a bunch of those. Venting is as easy as having a spare gas in connector or hitting the in poppet with a screw driver.

I use a Pin Lock Depressurizer $2.95 at MW, if I cant find it then a screwdriver

Man, they think of everything... even things that solve problems that barely exist!

Bobby_M said:

Man, they think of everything... even things that solve problems that barely exist!

Click to expand...

I got it after I pressed the wrong side in with my screwdriver once

SuperiorBrew said:

I got it after I pressed the wrong side in with my screwdriver once

Click to expand...

You made me spit coffee on my laptop!

I was fibbing a little it was actually twice

SuperiorBrew said:

I was fibbing a little it was actually twice

Click to expand...

It only took me once..................................

I did NOT know that one little poke would cover my entire kitchen, floor to ceiling, in beer. I'm still finding spots months later. NOW I know.

YooperBrew said:

It only took me once..................................

I did NOT know that one little poke would...

Click to expand...

Yeah, it only takes once...

YooperBrew said:

one little poke

Click to expand...

Surely you know the danger of 'one little poke' Yoops?

Is that like the game called "just the tip"?

Time to move this thread to a more appropriate forum. I've had quite a few beer showers trying to get my keg working. Luckily it is inside a refrigerator so I haven't had any severe messes to deal with.