Has anyone built a system using lower cost modular regulators (typically used in FRL air compressor systems)?
They seem like they'd work just fine... they have 1/4" thread varieties... have lots of selection and are typically fairly inexpensive ~$30 each...
I'm trying to figure out what I want to do in regards to regulators and this seems like a possible solution using a primary with a few of these as secondary...
They seem like they'd work just fine... they have 1/4" thread varieties... have lots of selection and are typically fairly inexpensive ~$30 each...
I'm trying to figure out what I want to do in regards to regulators and this seems like a possible solution using a primary with a few of these as secondary...