SOLD
Was about to start a new e-build but decided to go in a different direction.
Hopefully this will be a great deal for someone about to start their own e-brew project.
from Auber:
PID model #2352
RTD probe deluxe kit, 4" probe with 1/4" NPT (screw into BobbyM site-glass tee)
Auber's black project box (this is the only item that isn't "brand new," I cut 2 "notches" in the back in order to attach the heat sink. Pic below)
2 lighted push button swiches - 1 red & 1 blue
E-stop mushroom switch (and an e-stop panel plate from Grainger included)
LED light - 240v, orange color
thermal grease
from Amazon & other places:
40amp SSR
40amp heatsink
Packard C230B contactor, 30 amp w/ 120v coil
SPST toggle switch with on/off plate
L14-30 set locking plug & receptacle
L6-30 plug wired to about 7 feet of SOOW 10/2 with ground cable
Magnesium anode - 1/2" NPT
I'm in for about $240 on all this.
Will sell for $140 shipped
thanks for looking
Here's the Auber box with heat sink attached - notches cut out in the back, heat sink tapped down into nothes, and some silicone tubing sliced and put in there to provide some added support & heat buffering (tubing easily pulled out if you want).
Was about to start a new e-build but decided to go in a different direction.
Hopefully this will be a great deal for someone about to start their own e-brew project.
from Auber:
PID model #2352
RTD probe deluxe kit, 4" probe with 1/4" NPT (screw into BobbyM site-glass tee)
Auber's black project box (this is the only item that isn't "brand new," I cut 2 "notches" in the back in order to attach the heat sink. Pic below)
2 lighted push button swiches - 1 red & 1 blue
E-stop mushroom switch (and an e-stop panel plate from Grainger included)
LED light - 240v, orange color
thermal grease
from Amazon & other places:
40amp SSR
40amp heatsink
Packard C230B contactor, 30 amp w/ 120v coil
SPST toggle switch with on/off plate
L14-30 set locking plug & receptacle
L6-30 plug wired to about 7 feet of SOOW 10/2 with ground cable
Magnesium anode - 1/2" NPT
I'm in for about $240 on all this.
Will sell for $140 shipped
thanks for looking
Here's the Auber box with heat sink attached - notches cut out in the back, heat sink tapped down into nothes, and some silicone tubing sliced and put in there to provide some added support & heat buffering (tubing easily pulled out if you want).