hi all,
as I wait on my single tier to be put together I was going to order some of the parts i needed from bargain fittings. I just wanted some input on things I may be getting wrong or leaving out. I basically want the setup similar to what bobbyM has in his you tube. So i will need a bulkhead on all vessels, 2 on the MLT. ball valves on the vessels and the output of the pump. I want to go with the camlock QD. so I will need those plus the QD fitting for the vessels and the pump. This is what I have so far:
4 x Keg weldless bulkhead kit (he is out of the SS 3 peice valves i want)
- Valve No valve
- Hose barb No barb
1 x 1/2" NPT SS 2 piece ball valve (for the pump output)
4 x 1/2" NPT Street 90 elbow (i want an elbow on the end of each portion of silicone that connects to a vessel)
6 x 1/2" SS Camlock F style fitting Quick Disconnect (needed for obvious reasons)
10 x Silicone Tubing 1/2" ID x 3/4" OD (is this going to be enough?)
4 x 1/2" SS Camlock B Style Quick Disconnect (yeah, as i said, i wanna go with the camlock QD)
2 x 1/2" NPT Coupling (these are for the in/out of the march pump)
so what am i missing? I believe i am missing dip tubes, but i'm not sure how I want to go with that in combo with some sort of false bottom. I know I want to go plate chiller also...but i'm not sure of that setup either. trying to work through all of that in my head. Any comments would be appreciated.
TIA,
M
as I wait on my single tier to be put together I was going to order some of the parts i needed from bargain fittings. I just wanted some input on things I may be getting wrong or leaving out. I basically want the setup similar to what bobbyM has in his you tube. So i will need a bulkhead on all vessels, 2 on the MLT. ball valves on the vessels and the output of the pump. I want to go with the camlock QD. so I will need those plus the QD fitting for the vessels and the pump. This is what I have so far:
4 x Keg weldless bulkhead kit (he is out of the SS 3 peice valves i want)
- Valve No valve
- Hose barb No barb
1 x 1/2" NPT SS 2 piece ball valve (for the pump output)
4 x 1/2" NPT Street 90 elbow (i want an elbow on the end of each portion of silicone that connects to a vessel)
6 x 1/2" SS Camlock F style fitting Quick Disconnect (needed for obvious reasons)
10 x Silicone Tubing 1/2" ID x 3/4" OD (is this going to be enough?)
4 x 1/2" SS Camlock B Style Quick Disconnect (yeah, as i said, i wanna go with the camlock QD)
2 x 1/2" NPT Coupling (these are for the in/out of the march pump)
so what am i missing? I believe i am missing dip tubes, but i'm not sure how I want to go with that in combo with some sort of false bottom. I know I want to go plate chiller also...but i'm not sure of that setup either. trying to work through all of that in my head. Any comments would be appreciated.
TIA,
M