Hey all,
I was just looking at getting some information regarding the setup of my burners for my brewstand. My setup will consist of 3 low pressure 70,000 BTU burners that can be found here : http://www.agrisupply.com/burner-cast-low-presure-multi-hole-/p/40282/cn/5400000/
My question is what kind of regulators will I need and how many to go from either a propane tank or natural gas fitting (which is a future consideration for my build which is why I went with all low pressure burners) to all of my burners.
My boil kettle will be controlled manually and my hlt and mlt will be controlled by a vr8200 valve i found from honeywell.
If anyone could provide me with some advice for all regulators needed (preferably from agrisupply) and how to connect them all up would be greatly appreciated!!
Thanks,
Andrew
I was just looking at getting some information regarding the setup of my burners for my brewstand. My setup will consist of 3 low pressure 70,000 BTU burners that can be found here : http://www.agrisupply.com/burner-cast-low-presure-multi-hole-/p/40282/cn/5400000/
My question is what kind of regulators will I need and how many to go from either a propane tank or natural gas fitting (which is a future consideration for my build which is why I went with all low pressure burners) to all of my burners.
My boil kettle will be controlled manually and my hlt and mlt will be controlled by a vr8200 valve i found from honeywell.
If anyone could provide me with some advice for all regulators needed (preferably from agrisupply) and how to connect them all up would be greatly appreciated!!
Thanks,
Andrew