Firebat138
Well-Known Member
well... started and finished the same day... almost... Just gotta get the pumps and other stuff... Cutting the metal was fun..
I ended up cutting everything a little different... Here is the 2-1/2x1-1/2
These are the horiz pieces... I made mine 52" x 20"
|____________ 52"____|___20"_____|
----------------------------------------- x 4
These are the legs... you end up with 2 20" pieces left that are used for the pot supports. The width ended up 20" and the space in between is 15"
|__26"__|__26"__|__20"__|
----------------------------------------- x 2
I cut the 1-1/2 x 1-1/2 steel like below. These are the vertical supports
and pump mounts... I have 1 52" left... not sure what I need that for yet...
|__26"__|__26"__|__20"__|
----------------------------------------- x 1
|__26"__|__52"__|
----------------------------------------- x 1
And is this ok for hose?
gonna burn off tomorrow during our brew session...
I ended up cutting everything a little different... Here is the 2-1/2x1-1/2
These are the horiz pieces... I made mine 52" x 20"
|____________ 52"____|___20"_____|
----------------------------------------- x 4
These are the legs... you end up with 2 20" pieces left that are used for the pot supports. The width ended up 20" and the space in between is 15"
|__26"__|__26"__|__20"__|
----------------------------------------- x 2
I cut the 1-1/2 x 1-1/2 steel like below. These are the vertical supports
and pump mounts... I have 1 52" left... not sure what I need that for yet...
|__26"__|__26"__|__20"__|
----------------------------------------- x 1
|__26"__|__52"__|
----------------------------------------- x 1
And is this ok for hose?
gonna burn off tomorrow during our brew session...