StrangeDog
Member
So I'm in the process of brewing my second batch of beer... and racked it to a secondary fermeter for the first time. Everything is going smoothly until now...
My rubber stopper keeps sliding up out of the carboy I'm trying to put it in. I don't want to push it too far in so that I can't get it out or push it directly into the beer but don't quite know what to do...
I'm thinking the problem is just that inner lip of the carboy or the stopper is a little wet so it's sliding rather than getting the necessary friction needed to hold it in place.. Is that the case? Should I just let it dry a bit and try again?
Any other advice?
My rubber stopper keeps sliding up out of the carboy I'm trying to put it in. I don't want to push it too far in so that I can't get it out or push it directly into the beer but don't quite know what to do...
I'm thinking the problem is just that inner lip of the carboy or the stopper is a little wet so it's sliding rather than getting the necessary friction needed to hold it in place.. Is that the case? Should I just let it dry a bit and try again?
Any other advice?