mparmer
Well-Known Member
I've been running a little hot water in my LME jug and shaking it up real good to get all the LME out of there as it goes into the boil pot (a couple of times). It comes out foamy. Will this matter?
Thanks
Thanks
+1 on heating the LME. I throw mine in a sink full of hot water when I start getting ready to brew. It's nice and warm by the time I add it to the boil and is much easier to handle.
Not that we need a +1 of a +1, but +1! Let it sit in hot water and it will come out a lot easier.
I should have been more clear, I too place my containers in hot water to loosen the syrup as well, but even then there is a lot left inside, so I add some hot water inside the container and shake to get the maximum extraction. Sounds like the general consensus is that it's ok. Good, Thanks everyone. I'm getting more and more comfortable with my brewing skills thanks largely to the great folks on this forum.
Enter your email address to join: