I think I've finally decided to get an immersion chiller. Soon I'm going to start using a keggle. I was leaning towards this chiller from midwest: http://www.midwestsupplies.com/products/ProdByID.aspx?ProdID=4485
Will this fit well in a keggle? The chiller is 10" in diameter, so I'm guessing it will fit ok into the top I cut in the keg. But I'm not sure if the 23" to bend in the coil is enough.
Anyone else own this keggle and care to give reviews on it?
Will this fit well in a keggle? The chiller is 10" in diameter, so I'm guessing it will fit ok into the top I cut in the keg. But I'm not sure if the 23" to bend in the coil is enough.
Anyone else own this keggle and care to give reviews on it?