I built some heatsticks for first electric boil...I am ready to install them permanently in the keggle.
I have an electrician at work that is going to help me punch the holes but I just really want to make sure we do the right size.
Planning on using 2 2000w 120v sticks. I was able to get them up to a boil in 30 minutes from 75 degree water. Then unplugged 1 to hold the boil, worked flawlessly.
So from what I am reading is hole size of 1 1/4". I have attached a link with the element i am using from Home Depot. If anyone has used this please let me know.
http://www.homedepot.com/h_d1/N-5yc1v/R-202733441/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053
Thanks
JR
I have an electrician at work that is going to help me punch the holes but I just really want to make sure we do the right size.
Planning on using 2 2000w 120v sticks. I was able to get them up to a boil in 30 minutes from 75 degree water. Then unplugged 1 to hold the boil, worked flawlessly.
So from what I am reading is hole size of 1 1/4". I have attached a link with the element i am using from Home Depot. If anyone has used this please let me know.
http://www.homedepot.com/h_d1/N-5yc1v/R-202733441/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053
Thanks
JR