would this be suitable as a control pannel enclosure.
- Thread starter maida7
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
The10mmKid
Well-Known Member
Looks doable. Should be easy to work with.
It's not water-tite by any means.
Looks like you'll have to seal the unused knockouts.
Be careful with the SSR heatsink. I have no experience with how warm they get.
'da Kid
It's not water-tite by any means.
Looks like you'll have to seal the unused knockouts.
Be careful with the SSR heatsink. I have no experience with how warm they get.
'da Kid
maida7
Well-Known Member
I'm not using a heat sink so no worries. I don't have any ssr's just the pid and a 24v transformer to control 2 furnace valves with standing pilot lights. At least I don't think I need an ssr or a heatsink.
maida7
Well-Known Member
on further inspection the pids are 4" deep. I think I need a 6" deep box. I may just make my own out of plywood.
muhteeus
Well-Known Member
Similar threads
