Todd
Well-Known Member
I know someone makes a kit to do this without cutting. I just can't seem to figure out who it was.
Does anyone know?
Does anyone know?
david_42 said:The simplest way to switch back and forth is to install quick-disconnects into the lines.
Todd said:Can you show me what you mean?
You use qd's for airtools on beer lines? I thought of doing this until I pulled a female fitting apart and found that they had put it together with locktite and that they seal with rubber. I would love to be able to use free qd's on my new 3 tier. Tell me what you knowBobby_M said:You can even use disconnects meant for air tools, kits from northerntool.com are dirt cheap. You just have to get the appropriate hose barbs. I'd use the female for the faucet/co2 side, then the cheaper nipples on the corny/sanke.
Enter your email address to join: