neumann
Well-Known Member
I almost hate to post another thread with brew stand build pics but I'm just so dang excited...
It's a single tier based loosely off bobbym's design. 1.5"x16ga. square tube. Chugger Pump. Propane burners from AgriSupply. Fittings from Bargain Fittings. Sightglasses and thermometers from BobbyM. My brother-in-law has been helping me weld it up. We got the last of the frame put together this weekend. Hoping to get the casters, pump and gas plumbing mounted this weekend. Once that happens a wet test will follow. I should be able to brew by the end of September. :rockin:
If anyone has any questions about my process, I'll do my best answer them. I didn't do much photo documentation partly because it has been done so well already but mostly because I'm lazy.
It's a single tier based loosely off bobbym's design. 1.5"x16ga. square tube. Chugger Pump. Propane burners from AgriSupply. Fittings from Bargain Fittings. Sightglasses and thermometers from BobbyM. My brother-in-law has been helping me weld it up. We got the last of the frame put together this weekend. Hoping to get the casters, pump and gas plumbing mounted this weekend. Once that happens a wet test will follow. I should be able to brew by the end of September. :rockin:
If anyone has any questions about my process, I'll do my best answer them. I didn't do much photo documentation partly because it has been done so well already but mostly because I'm lazy.