WBC
Well-Known Member
I have been using origional Sanke keg spear o-rings but need new ones. Does anyone have the correct O-ring specifications or the part number? I have searched all over the place to find this but no success.
Sanke spear O-ring
- Thread starter WBC
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
foppa78
Well-Known Member
I dont know the exact replacement but I have used these before and they are cheap and even easier to get in and out.
http://cgi.ebay.com/SNAP-RINGS-REUS...VQQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247
http://cgi.ebay.com/SNAP-RINGS-REUS...VQQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247
OP
OP
WBC
Well-Known Member
Thanks, I found those too but want just the o-ring in a 25 pack to reduce cost.
Install Tip: You can use a piece of 1/2 sq steel tubing under the rolled edge of the keg as a lever to push on a 1/2 PVC end cap to compress the o-ring when installing. a 2.5 foot long lever can be held by a helper while you install the snap ring.
Edit: I measured everything and the only one that comes close is #5018T261 1 3/4 ID X 2 in OD x .125 section from McMaster.com.
Install Tip: You can use a piece of 1/2 sq steel tubing under the rolled edge of the keg as a lever to push on a 1/2 PVC end cap to compress the o-ring when installing. a 2.5 foot long lever can be held by a helper while you install the snap ring.
Edit: I measured everything and the only one that comes close is #5018T261 1 3/4 ID X 2 in OD x .125 section from McMaster.com.
- Joined
- Nov 6, 2007
- Messages
- 62,016
- Reaction score
- 6,922
Hate to bring this back after over a few weeks, But any idea what size those rings are. I wanna switch my spring clips over
Similar threads
