inhousebrew
Well-Known Member
Just looking at sourcing out a project box for this and no, I'm not going the easy route and just ordering one from the website. I know the screen on the outside is less than 2"x2" but how deep do they run into the box?
Size of the aubrins 1/16, 2352 PID?
- Thread starter inhousebrew
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
goybar
Well-Known Member
I would like to know this as well. Auber Ins. doesn't include this information.
I was thinking about using Console type enclosure like these:
http://www.automationdirect.com/adc...onsoles_-a-_Consolets/WC-C_Operator_Consolets
Chris
I was thinking about using Console type enclosure like these:
http://www.automationdirect.com/adc...onsoles_-a-_Consolets/WC-C_Operator_Consolets
Chris
jeffmeh
Well-Known Member
- Joined
- Feb 26, 2009
- Messages
- 2,145
- Reaction score
- 216
Per Kal, you want 45mm x 45mm square holes for the 1/16 DIN devices, like the 2352 PID.
http://www.theelectricbrewery.com/control-panel-part-1?page=6
http://www.theelectricbrewery.com/control-panel-part-1?page=6
smittygouv30
Well-Known Member
The 2352 is 100mm depth or 3.94 inches. This is straight from their downloadable manual.
Corey
Corey
OP
OP
inhousebrew
Well-Known Member
thanks for that. I must have missed it in the manual :smack:
smittygouv30
Well-Known Member
No worries. I've been battling the same question. I want to order the auber enclosure 12x16x6 but am unsure how everything will fit. I think I'm gonna takes chance and try it anyway but certain things will have to be staggered as the PIDs are pretty deep.
goybar
Well-Known Member
I missed it too, I have looked though several times.
Thanks,
Chris
Thanks,
Chris
