Jet burner orifice size?

Can someone with a low pressure 10 tip jet burner please tell me what the orifice size is? I have a 44 tip high pressure burner and im planning to make three small burners and run on low pressure. Thanks

Anyone have one that could help me out??

You did not say which gas you were going to be using:

The burner is an impinging jet design. The natural gas burner has an orifice that is a #56 wire drill gage size. If it has one, the pilot jet has the same size orifice.

The propane burner of the same design has jets that are #75 wire drill gage size. The pilot jet is also the same size.

Hope this helps.

BTW - this is from measurements that I took from my burners way back in January of 2007. I had to dig up the info from when I had posted it in another forum.

Thank you so much, i want to keep it propane just use low pressure. is that the size for lp lp?

cgondoli1 said:

Thank you so much, i want to keep it propane just use low pressure. is that the size for lp lp?

Click to expand...

That is the correct size for low pressure propane. #75 wire drill gage.

Thanks! tomorrow i can get to drillin!