I have looked through as many of the posts as I could and haven't seen what I am looking for (doesn't mean it is not there, I just haven't found it).
I really want a tower, but think keezers much more attractive in general than kegarators. What if I got a small chest freezer, did the collar, and then attempted to remove the hinge from one side of the lid, move it over, cut the lid in two and put a tower on the now non-moving third of the thing? I would have to move the hinge over to the other section and go from there. that part of the keezer lid would operate as normal and on a small freezer I'd still be able to access the whole interior. I'll attach a little diagram of the idea below. Would this be possible, or do you think the cut too difficult to make? If someone has done it point me that direction please.
I really want a tower, but think keezers much more attractive in general than kegarators. What if I got a small chest freezer, did the collar, and then attempted to remove the hinge from one side of the lid, move it over, cut the lid in two and put a tower on the now non-moving third of the thing? I would have to move the hinge over to the other section and go from there. that part of the keezer lid would operate as normal and on a small freezer I'd still be able to access the whole interior. I'll attach a little diagram of the idea below. Would this be possible, or do you think the cut too difficult to make? If someone has done it point me that direction please.