CodeRage
Death by Magumba!
So I decided to try to polish a keg today. I had some 60 grit aluminum oxide for my blaster so I figured I would give that a go. It put on a heavy heavy matte finish. Looked good and was consistant but not what I was looking for. So I only did a small section of it. Took some various angle grinder pads I had, (heavy, medium, and fine scrubby types) and got descent results. They are a TON of work though and I am sure it will take $100 worth of pads to do the whole thing...
Oh, where I blasted with the aluminum oxide turned rock hard and didnt take the pad as nicely as the other spots.
So I am thinking about going back to media blasting but would like to get it down to something I can polish. I know I cant use steel shot but what about glass bead or walnut and finally soda. Any one have any experience with this or recomendations?
Oh, where I blasted with the aluminum oxide turned rock hard and didnt take the pad as nicely as the other spots.
So I am thinking about going back to media blasting but would like to get it down to something I can polish. I know I cant use steel shot but what about glass bead or walnut and finally soda. Any one have any experience with this or recomendations?