kbuzz
Well-Known Member
I finished my stir plate build a couple hours ago and I'm having problems getting the bar to spin continuously...I think the DC charger is giving it too much power because even when turned on to the lowest speed, the bar will spin okay for just a couple seconds as the fan is speeding up...then once it hits peak speed, the bar gets thrown.
I'm currently using a 12V / 1000mA charger. So I found a couple other options laying around the house...which do you think would work best:
12V / 200mA...or a 5V / 2.5A (2500mA)?
I'm currently using a 12V / 1000mA charger. So I found a couple other options laying around the house...which do you think would work best:
12V / 200mA...or a 5V / 2.5A (2500mA)?