foppa78
Well-Known Member
My 3 way co2 secondary has threaded connections out instead of the barbed connections that I had expected. How would I connect gas line to these threaded ends?
CO2 connection help
- Thread starter foppa78
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
jdoiv
Well-Known Member
You could just buy barb connectors that thread right on. Use a little teflon tape and your good to go.
OP
OP
foppa78
Well-Known Member
Would these barb connectors just screw onto my existing male threads? I dont know if I have seen a female thread to barb. Or are you suggesting that I remove these male threads that are already screwed in?
Remove and replace with these:
http://pivo.northernbrewer.com/nbstore/action/search-do?searchTerm=K039&x=39&y=8
or use these:
http://pivo.northernbrewer.com/nbstore/action/search-do?searchTerm=K123
http://pivo.northernbrewer.com/nbstore/action/search-do?searchTerm=K039&x=39&y=8
or use these:
http://pivo.northernbrewer.com/nbstore/action/search-do?searchTerm=K123
rjester
Active Member
I think this is what you are looking for.
http://www.austinhomebrew.com/product_info.php?cPath=178_40_131_575&products_id=1272
or
http://northernbrewer.com/tubing.html Scroll down to barbed swivel nuts.
http://www.austinhomebrew.com/product_info.php?cPath=178_40_131_575&products_id=1272
or
http://northernbrewer.com/tubing.html Scroll down to barbed swivel nuts.
OP
OP
foppa78
Well-Known Member
You guys are great. These will work. Thank you!!
Um... those gauges are not quite right for beer. Dialing in a precise 9-12 PSI is going to be tough because the range is too large.
mr x
Well-Known Member
Good eyes.Bobby_M said:
OP
OP
foppa78
Well-Known Member
Yeah the one of the left may work but the other two may need to be replaced.
